Last Updated : Jan. 20th. 1998 

Welcome to the home page of

3D FEM Blow Molding Simulation

 
 

Introduction:
 
 

Examples: (Click the pictures)
 

 

PET Bottle's Stretch Blow Molding Simulation
Click it
 
Polymer's Thermoforming Process
Under ConstructionUnder Construction
All Rights Reserved.

This page is created by Song Wang, who is a doctor candidate and will graduate in 1998 from The University of Tokyo. The contents of this page are some results of his research work which were conducted in RIKEN, Japan.

If you have comments or suggestions,
email S. Wang at swang@postman.riken.go.jp

or contact at the following address

Song Wang
Materials Fabrication Lab.
The Institute of Physical and Chemical Research, RIKEN
Hirozawa 2-1, Wako-Shi, Saitama
Japan
Tel: 81-048-467-9315
Fax: 81-048-462-4657
 

Back to Blow Molding Home PageBack to Research Subjects.